Hood Support Fastening Clip
2006 Nissan X-trail T30
May 7, 2026
Use the built-in measurement tool to verify fit before downloading or ordering.
Description
As with everyone with a little bit older Japanese car, the fastener for the hood support was broken on my 2006 X-Trail T30. So why not model it and make a print? This part is not 100% same as the original. I placed the V-shaped clip on the edge instead of in the middle. This way it is easier to print because you do not need supports.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Loading pricing...
Use the built-in measurement tool to verify fit before downloading or ordering.
Part Description
As with everyone with a little bit older Japanese car, the fastener for the hood support was broken on my 2006 X-Trail T30. So why not model it and make a print? This part is not 100% same as the original. I placed the V-shaped clip on the edge instead of in the middle. This way it is easier to print because you do not need supports.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed