This is a remix of the cupholder below, essentially the same concept just that i found the circle cup holder a bit to small for the larger drinks so i just made it to where its two holes for lager drinks. This is meant to go in the center console. The center console will still function and close with this.
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
This is a remix of the cupholder below, essentially the same concept just that i found the circle cup holder a bit to small for the larger drinks so i just made it to where its two holes for lager drinks. This is meant to go in the center console. The center console will still function and close with this.
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed