Part Description

this is a switch panel to mount over the rear view panel. this is a very preliminary design but please give feedback. it takes 8 switches: 2 of these https://rockerswitchpros.com/product/end/ 6 of these https://rockerswitchpros.com/product/mdl/ you also need to figure out mounting, I used melt in nuts and drilled some holes in the plastic trim. you will also need to cut the panel since the switches will pop through.

Print Instructions

Standard FDM printing settings:
- Layer height: 0.2mm
- Infill: 70%
- Supports: As needed