Toggle Switch Holder
2007-2018 Jeep Wrangler JK
Description
This part is designed to hold standard round toggle switches in the coin tray in front of the 4wd lever. I recommend removing the rubber liner then using double sided sticky tape to secure it to the tray. My goal was a removable switch block that didn't make holes in the factory plastic. I suppose if you were so inclined you could run a small screw through the bottom to secure it, you would have to drive the screw through the hole intended for the switch.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This part is designed to hold standard round toggle switches in the coin tray in front of the 4wd lever. I recommend removing the rubber liner then using double sided sticky tape to secure it to the tray. My goal was a removable switch block that didn't make holes in the factory plastic. I suppose if you were so inclined you could run a small screw through the bottom to secure it, you would have to drive the screw through the hole intended for the switch.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed