Gauge Pod
2007-2013 Mini Cooper S R56
Description
Use whatever the latest version is. I keep printing and then adjusting the spacing little by little. I also have a single cup pod (look under my profile) that works a little better because it swivels. If you are link me and stripped the screw hole in the back of the tach then the three screw frame design here might work out better for you. Used the hole layout and frame from the original and remixed for a standard 52mm gauge. Have not printed or test fit. WIP Print in PETG or ABS and not PLA obviously.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Use whatever the latest version is. I keep printing and then adjusting the spacing little by little. I also have a single cup pod (look under my profile) that works a little better because it swivels. If you are link me and stripped the screw hole in the back of the tach then the three screw frame design here might work out better for you. Used the hole layout and frame from the original and remixed for a standard 52mm gauge. Have not printed or test fit. WIP Print in PETG or ABS and not PLA obviously.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed