Center Console Cup Holder Insert
2007 Suzuki Jimny
Description
A PETG part for the central empty space between the chairs and under the handbrake. The part was first sized with laser cutting wood model, and then it was printed for use with a Prusa MK3 with very low infill. The place for the cup holders is designed to fit a further rubber piece made for Tesla center console. The part is a bit taller to press fit in place, however, the extra 2-3 mm didn't do much and only caused a bit of deformation so, I would suggest scaling the whole thing down in the x-y direction. The z-direction height of the central part is a bit shorter than normal to save materials but, the rubber part proved very efficient in compensating that difference. The link for the rubber part, which proved very efficient https://www.amazon.sa/-/en/Tersely-Console-Compatible-Storage-Accessories/dp/B0C3VM3HW3/ref=sr_1_8?crid=1A344FWALRYQF&keywords=tesla%2Bcup%2Bholder&qid=1696145617&sprefix=tesla%2Bcup%2Caps%2C189&sr=8-8&th=1
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
A PETG part for the central empty space between the chairs and under the handbrake. The part was first sized with laser cutting wood model, and then it was printed for use with a Prusa MK3 with very low infill. The place for the cup holders is designed to fit a further rubber piece made for Tesla center console. The part is a bit taller to press fit in place, however, the extra 2-3 mm didn't do much and only caused a bit of deformation so, I would suggest scaling the whole thing down in the x-y direction. The z-direction height of the central part is a bit shorter than normal to save materials but, the rubber part proved very efficient in compensating that difference. The link for the rubber part, which proved very efficient https://www.amazon.sa/-/en/Tersely-Console-Compatible-Storage-Accessories/dp/B0C3VM3HW3/ref=sr_1_8?crid=1A344FWALRYQF&keywords=tesla%2Bcup%2Bholder&qid=1696145617&sprefix=tesla%2Bcup%2Caps%2C189&sr=8-8&th=1
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed