Trunk Latch Rod Clip
2007-2011 Toyota Camry
May 4, 2026
Use the built-in measurement tool to verify fit before downloading or ordering.
Description
* Needs support. * Should be printed with .1 layer height. * Should be printed with either PLA-CF, PETG or ABS for strength reasons.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Loading pricing...
Use the built-in measurement tool to verify fit before downloading or ordering.
Part Description
* Needs support. * Should be printed with .1 layer height. * Should be printed with either PLA-CF, PETG or ABS for strength reasons.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed