Door Cup Holder Vape Insert
2007 Ford Focus (ZX4 SE)
Description
Seemed to fit pretty well in my '07 Focus ZX4 SE driver door cupholder. Sized for a Smok Priv II box mod, but easily changed in Fusion 360. Made slices in the bottom with razor blade and used silicone adhesive to keep snug to door cupholder, will see if keeps if from pulling out when I grab my vape (I could probably use a fraction more clearance in the box mod cutout) Problem was cup holder in door isn't full circle, so vape slides out of cup holder on regular basis. Keeping in my hand wasn't desirable either while driving. This promises to make quickly accessible your vape while rocking your Focus at 30+ mpg.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Seemed to fit pretty well in my '07 Focus ZX4 SE driver door cupholder. Sized for a Smok Priv II box mod, but easily changed in Fusion 360. Made slices in the bottom with razor blade and used silicone adhesive to keep snug to door cupholder, will see if keeps if from pulling out when I grab my vape (I could probably use a fraction more clearance in the box mod cutout) Problem was cup holder in door isn't full circle, so vape slides out of cup holder on regular basis. Keeping in my hand wasn't desirable either while driving. This promises to make quickly accessible your vape while rocking your Focus at 30+ mpg.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed