Wireless Charger Ashtray Replacement
2008 Bmw 3 Series E9X
Description
I designed this to replace the ashtray in my 2008 e92, but this should work for any BMW e9X model. This design will hold a Samsung Galaxy S21 with a case measuring 80mm wide. I printed in black ASA at .20mm with Supports. It is best to reorientate flat before printing. I have attached the Fusion360 file if you want to attempt to change the size, but it may be best to just use the file as a guide. Below is the Inbay Wireless Charging Kit that was used. https://www.ecstuning.com/b-inbay-parts/wireless-charging-retrofit-kit-3-coil/240000-03~iby/?gclid=CjwKCAiA3L6PBhBvEiwAINlJ9Azw-8ybrMDp4lYes29nIvGrPaZN64pQCU_94IeViUUytapodKJ8lxoCFVcQAvD_BwE
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
I designed this to replace the ashtray in my 2008 e92, but this should work for any BMW e9X model. This design will hold a Samsung Galaxy S21 with a case measuring 80mm wide. I printed in black ASA at .20mm with Supports. It is best to reorientate flat before printing. I have attached the Fusion360 file if you want to attempt to change the size, but it may be best to just use the file as a guide. Below is the Inbay Wireless Charging Kit that was used. https://www.ecstuning.com/b-inbay-parts/wireless-charging-retrofit-kit-3-coil/240000-03~iby/?gclid=CjwKCAiA3L6PBhBvEiwAINlJ9Azw-8ybrMDp4lYes29nIvGrPaZN64pQCU_94IeViUUytapodKJ8lxoCFVcQAvD_BwE
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed