Center Console Latch
2008 Toyota 4runner
May 4, 2026
Use the built-in measurement tool to verify fit before downloading or ordering.
Description
The latch for the lid of the center console of a 2008 Toyota 4Runner. Recommended to print on its side with supports for the tooth. Note: supports were somewhat difficult to remove from inner gap. I received good results with Hatchbox PETG at 15% infill, but to optimize strength and pliability you may have to modify the infill to match your filament.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Loading pricing...
Use the built-in measurement tool to verify fit before downloading or ordering.
Part Description
The latch for the lid of the center console of a 2008 Toyota 4Runner. Recommended to print on its side with supports for the tooth. Note: supports were somewhat difficult to remove from inner gap. I received good results with Hatchbox PETG at 15% infill, but to optimize strength and pliability you may have to modify the infill to match your filament.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed