Hvac Mix Door Lever
2009 Ford Explorer
Description
<s>I apologize that I didn't do this sooner, when I remembered exactly what vehicle I was working on at the time.</s> EDIT: I found a pic of the vin! Info Updated I made this part to repair a 2009 Ford Explorer that wouldn't blow air out the panel vents. I opened the glove box and dropped it down so i could access behind it. I found this little piece with the arm broken clean off. It pulled straight out. Ford only offered it as part of a $400 assembly, that I would have to remove the dash to install. I changed the design to take a screw where the old one had a plastic pivot. It's not parametric but I have included the (messy) openscad file.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
<s>I apologize that I didn't do this sooner, when I remembered exactly what vehicle I was working on at the time.</s> EDIT: I found a pic of the vin! Info Updated I made this part to repair a 2009 Ford Explorer that wouldn't blow air out the panel vents. I opened the glove box and dropped it down so i could access behind it. I found this little piece with the arm broken clean off. It pulled straight out. Ford only offered it as part of a $400 assembly, that I would have to remove the dash to install. I changed the design to take a screw where the old one had a plastic pivot. It's not parametric but I have included the (messy) openscad file.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed