Cup Holder Insert
2009 Toyota Tacoma 2nd Gen
Description
I created this based on the idea found I believe from the 4Runner's and adopted it to work with my 2nd Gen Tacoma (2009.) I built using PLA at 0.2mm layer height and it looks great. I would recommend 4 solid top & bottom layers & 2-3 outlines. Been using for 2.5 years now and it's still going strong. You will need to print: 1x body 2x Wings (Symmetrical) Purchase Separately: 2x 1.5" long counter-sunk 10-24 screws (will thread directly into plastic when printed) 2 springs to fit length & desired resistance (I believe I bought 3"x1/4" springs) This is my first Thing so let me know what y'all think
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
I created this based on the idea found I believe from the 4Runner's and adopted it to work with my 2nd Gen Tacoma (2009.) I built using PLA at 0.2mm layer height and it looks great. I would recommend 4 solid top & bottom layers & 2-3 outlines. Been using for 2.5 years now and it's still going strong. You will need to print: 1x body 2x Wings (Symmetrical) Purchase Separately: 2x 1.5" long counter-sunk 10-24 screws (will thread directly into plastic when printed) 2 springs to fit length & desired resistance (I believe I bought 3"x1/4" springs) This is my first Thing so let me know what y'all think
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed