Center Console Armrest Lid Latch
2010-2015 Ford F-150
Description
I broke my original latch on my 2012 F-150. I remixed this and made the pins braces a little narrower to make it easier to put in i also removed the 3d printed spring part and reinforced the pins instead this was still a very tight fit you might need to still sand the pins down shorter. might modify more if it breaks in future. A paper clip spring will work but If you have original spring, use that instead. attached is a youtube of how to install the latch i do not own this video. https://www.youtube.com/watch?v=ic1-wjW6yOk
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
I broke my original latch on my 2012 F-150. I remixed this and made the pins braces a little narrower to make it easier to put in i also removed the 3d printed spring part and reinforced the pins instead this was still a very tight fit you might need to still sand the pins down shorter. might modify more if it breaks in future. A paper clip spring will work but If you have original spring, use that instead. attached is a youtube of how to install the latch i do not own this video. https://www.youtube.com/watch?v=ic1-wjW6yOk
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed