Taillight Bracket
2010 Mazda 3 (Hatchback)
Description
These are the pieces that hold the taillight tight to the hatch. The originals seemed a little lacking, at least in my case. My car had apparently been wrecked before I bought it, and the hatch was just a little out of shape, so the taillight leaked, and the light literally popped off when I closed the truck yesterday. I printed these, they have a wider area to tighten against the hatchback, and seemed to come out pretty well. I reused the nuts off of the old brackets.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
These are the pieces that hold the taillight tight to the hatch. The originals seemed a little lacking, at least in my case. My car had apparently been wrecked before I bought it, and the hatch was just a little out of shape, so the taillight leaked, and the light literally popped off when I closed the truck yesterday. I printed these, they have a wider area to tighten against the hatchback, and seemed to come out pretty well. I reused the nuts off of the old brackets.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed