Nilight 4-gang Switch Box Mount
2010-2014 Subaru Outback
Description
As I was installing my roof lights on my 2012 Subaru Outback, I was trying to figure out where to mount the switchbox for them. I discovered that I could remove a cubby from the center console and decided to make a bracket to replace that cubby with the switchbox. *** This bracket only holds the Nilight 4-gang Switch Box *** Fits: 2010-2012 Subaru Outback 2010-2014 Subaru Legacy Installation: 1. Remove the front panel. This video demonstrates it well: https://www.youtube.com/watch?v=6lx1XpflgZE&t=101s 2. Remove the cubby that comes with that panel via 4 philips head screws. (Save these screws, as this design uses OEM hardware) 3. Replace the panel with the 3D Printed bracket 4. Reinstall the front panel with the new bracket attached. Feel free to ask any more questions you may have in the comments.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
As I was installing my roof lights on my 2012 Subaru Outback, I was trying to figure out where to mount the switchbox for them. I discovered that I could remove a cubby from the center console and decided to make a bracket to replace that cubby with the switchbox. *** This bracket only holds the Nilight 4-gang Switch Box *** Fits: 2010-2012 Subaru Outback 2010-2014 Subaru Legacy Installation: 1. Remove the front panel. This video demonstrates it well: https://www.youtube.com/watch?v=6lx1XpflgZE&t=101s 2. Remove the cubby that comes with that panel via 4 philips head screws. (Save these screws, as this design uses OEM hardware) 3. Replace the panel with the 3D Printed bracket 4. Reinstall the front panel with the new bracket attached. Feel free to ask any more questions you may have in the comments.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed