Rear Dashcam Mount
2010-2024 Toyota 4runner 5th Gen
Description
Designed a dashcam mount for the Viofo A129 Pro Duo rear camera, to be screwed into the center upholstery pin of a Toyota 4Runner with an M6x20 Bolt. Curves to the roof to keep it straight, almost no movement whatsoever of the camera. Camera fits in VERY tightly, adhesive use is unnecessary. Recommended to print with a resin printer, FDM is theoretically possible but awkward with supports. Almost any material would be viable though PLA is obviously dangerous in a hot car.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Designed a dashcam mount for the Viofo A129 Pro Duo rear camera, to be screwed into the center upholstery pin of a Toyota 4Runner with an M6x20 Bolt. Curves to the roof to keep it straight, almost no movement whatsoever of the camera. Camera fits in VERY tightly, adhesive use is unnecessary. Recommended to print with a resin printer, FDM is theoretically possible but awkward with supports. Almost any material would be viable though PLA is obviously dangerous in a hot car.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed