Head Unit Mounting Bracket
2010-2015 Toyota Prius ZVW30
Description
The standard KINGBEATS K2+ for the 2010 Toyota Prius ZVW30 is mounted onto the radio frame using an adapter frame. Both frames are equipped with clips. However, this standard adapter frame didn’t fit into the radio frame. I had to trim the adapter frame and its clips slightly. This resulted in the adapter frame falling through the radio frame. So, I decided to print the mounting based on the standard metal mounting that comes with the head unit. My model is for the right-side mounting. The left-side mounting is symmetrical, so you would have to mirror my model. I printed my mounting using supports. The orientation of the mounting model is presented on the screen shots from Ultimaker Cura attached below. I’m sharing this model with you, guys. Hope it’ll be of use.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
The standard KINGBEATS K2+ for the 2010 Toyota Prius ZVW30 is mounted onto the radio frame using an adapter frame. Both frames are equipped with clips. However, this standard adapter frame didn’t fit into the radio frame. I had to trim the adapter frame and its clips slightly. This resulted in the adapter frame falling through the radio frame. So, I decided to print the mounting based on the standard metal mounting that comes with the head unit. My model is for the right-side mounting. The left-side mounting is symmetrical, so you would have to mirror my model. I printed my mounting using supports. The orientation of the mounting model is presented on the screen shots from Ultimaker Cura attached below. I’m sharing this model with you, guys. Hope it’ll be of use.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed