Usb Blank Port Replacement
2010-2015 Toyota Prius Gen 3
Description
Designed this to make a USB flush mount I bought on ebay fit in place of the blanking plate on my 2010 Prius. I didn't want to design clips, so it's made to friction fit into the hole, and the USB port friction fits in as well. This should work for any of the dash blank plates on the gen 3 prius, and also may work on other Toyota models of similar years. Print in a heat and UV resistant filament such as PETG, ABS, or ASA. Print wide-end-down with supports. The USB cable I used is a pretty generic one you can find on ebay, amazon, etc. I've included a photo for reference. Here's the listing to the item I bought: https://www.ebay.com/itm/257372226001 Description (in case the listing is removed): "USB 3.0 Panel Flush Mount Cable - Single USB 3.0 Male to Female AUX Car Mount"
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Designed this to make a USB flush mount I bought on ebay fit in place of the blanking plate on my 2010 Prius. I didn't want to design clips, so it's made to friction fit into the hole, and the USB port friction fits in as well. This should work for any of the dash blank plates on the gen 3 prius, and also may work on other Toyota models of similar years. Print in a heat and UV resistant filament such as PETG, ABS, or ASA. Print wide-end-down with supports. The USB cable I used is a pretty generic one you can find on ebay, amazon, etc. I've included a photo for reference. Here's the listing to the item I bought: https://www.ebay.com/itm/257372226001 Description (in case the listing is removed): "USB 3.0 Panel Flush Mount Cable - Single USB 3.0 Male to Female AUX Car Mount"
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed