Dash Change Holder
2011 Chevrolet Silverado
Description
This cubby is on the right side of the center cluster. In higher-end (AKA loaded!) trucks some controls go here. But for many of us who don't pay $80K for a vehicle, these are little cubby holes that are useless. So I measured it, went through several fittings and finally came up with this. It works in most materials. I used TPU because it's exposed to temperature extremes and sunlight.
Print Instructions
Printer Brand: Creality Printer: Ender-3 V3 KE Rafts: No Supports: Yes Infill: 25%
Part Description
This cubby is on the right side of the center cluster. In higher-end (AKA loaded!) trucks some controls go here. But for many of us who don't pay $80K for a vehicle, these are little cubby holes that are useless. So I measured it, went through several fittings and finally came up with this. It works in most materials. I used TPU because it's exposed to temperature extremes and sunlight.
Print Instructions
Printer Brand: Creality Printer: Ender-3 V3 KE Rafts: No Supports: Yes Infill: 25%