Rearview Camera Bracket
2011-2016 Honda Cr-z
Description
(Model has been updated as of 04/17/2026. I've added an extra feature to help the camera face straight backwards. All previous suggestions are still valid.) (Model has been updated as of 8/17/25. Print on the rear flat surface. The model will be slanted, yet requiring less support and resulting in a higher durability. I have added small ribs next to the camera to further increase durability. ) Default is '30D'. 30 Degrees. Print with 5 walls, increase that if raising to a steeper degree. 40 degrees requires 7 walls. Print with hybrid tree supports, painting support on the screw holes on the lower face. Supports on the pop-clip holes is entirely optional. Near-zero cleanup work required. Print on the flat back surface. All other orientations are inferior. This is a copied version of the OEM rearview camera bracket for the CR-Z. Minor changes made to allow for easier printing. I intend for this to be used with a 24mmx24mmx30mm style camera. My camera was approximately 30mm long (T'eyes) however, shorter cameras may still work. Mounting is utilizing the two screws. I think this may be a universal mounting style adopted by most rearview cameras, including the OEM rearview camera. All CR-Z bumpers have the cutout to use it. Use a pop clip to install. The latest model has an alignment tooth (2026:"and a rounded feature") that actually clicks into place in the non-popclip hole. It works quite well. Provide feedback! I will take your feedback to modify the model.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
(Model has been updated as of 04/17/2026. I've added an extra feature to help the camera face straight backwards. All previous suggestions are still valid.) (Model has been updated as of 8/17/25. Print on the rear flat surface. The model will be slanted, yet requiring less support and resulting in a higher durability. I have added small ribs next to the camera to further increase durability. ) Default is '30D'. 30 Degrees. Print with 5 walls, increase that if raising to a steeper degree. 40 degrees requires 7 walls. Print with hybrid tree supports, painting support on the screw holes on the lower face. Supports on the pop-clip holes is entirely optional. Near-zero cleanup work required. Print on the flat back surface. All other orientations are inferior. This is a copied version of the OEM rearview camera bracket for the CR-Z. Minor changes made to allow for easier printing. I intend for this to be used with a 24mmx24mmx30mm style camera. My camera was approximately 30mm long (T'eyes) however, shorter cameras may still work. Mounting is utilizing the two screws. I think this may be a universal mounting style adopted by most rearview cameras, including the OEM rearview camera. All CR-Z bumpers have the cutout to use it. Use a pop clip to install. The latest model has an alignment tooth (2026:"and a rounded feature") that actually clicks into place in the non-popclip hole. It works quite well. Provide feedback! I will take your feedback to modify the model.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed