Aux Switch Panel Sun Visor Bracket
2011-2021 Jeep Grand Cherokee WK2
Description
Hey there, I was looking for a smart and convenient place to hold my AUX switch in the car so it doesn't interrupt anything. I'm not a big fan of screwing things directly to the dashboard and on the other hand I didn't wanted to have it loose with cable dangling all around. It's designed to fit Aliexpress Colight 8 gang AUX panel into my 2011 Jeep Grand Cherokee WK2. Not sure but it seems to me that AUXBEAM switch panel is pretty similar to the one I have. I believe the same sun visor was used until the end of WK2 production as well as for Dodge Durangos. You can easily remix it to fit any other car or switch panel - I'm including STEP file. Recommend using PETG for that application. You'll also need 6x M3x10 countersunk screws to secure the brackets to AUX panel bracket_v1: 5mm thick, no screw holes, no embossment (I used it only to check if it fits visor, 5mm is too thick and top stiff due to that) bracket_v2: 3mm thick (fits far better, still sturdy), with 20mm width embossment fitting switch panel and screw holes (20mm fits very tight) bracket_v3: 3mm thick, with 19mm width embossment fitting switch panel and screw holes (fits little loose)
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Hey there, I was looking for a smart and convenient place to hold my AUX switch in the car so it doesn't interrupt anything. I'm not a big fan of screwing things directly to the dashboard and on the other hand I didn't wanted to have it loose with cable dangling all around. It's designed to fit Aliexpress Colight 8 gang AUX panel into my 2011 Jeep Grand Cherokee WK2. Not sure but it seems to me that AUXBEAM switch panel is pretty similar to the one I have. I believe the same sun visor was used until the end of WK2 production as well as for Dodge Durangos. You can easily remix it to fit any other car or switch panel - I'm including STEP file. Recommend using PETG for that application. You'll also need 6x M3x10 countersunk screws to secure the brackets to AUX panel bracket_v1: 5mm thick, no screw holes, no embossment (I used it only to check if it fits visor, 5mm is too thick and top stiff due to that) bracket_v2: 3mm thick (fits far better, still sturdy), with 20mm width embossment fitting switch panel and screw holes (20mm fits very tight) bracket_v3: 3mm thick, with 19mm width embossment fitting switch panel and screw holes (fits little loose)
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed