Windshield Washer Fluid Reservoir Cap
2012 Ford Focus
Description
I have a Ford Focus 2012 (Hatchback) and after 9+ years of prolonged heat, the windshield wiper tank cap decided to disintegrate. I whipped this up it Fusion 360 and printed it in PETG. This cap may fit newer ford(s) vehicles. Update 02/23/22: Added a jacket to fit around the outside of the wiper tube along with fitting inside, this will prevent the part from spinning. Feedback from the community, I adjusted the tolerances for the base to fit inside the wiper base. Update 02/25/22: Update the “FordFocus2012_WindshieldWiper_v3_Base_Revised_v1.stl” Increase thread tolerances for certain printers. Update 03/01/22: Fixed thread alignment, simulation was set up incorrectly. Logos will align with the notch on the base. See attached photo. Updated files: FordFocus2012_WindshieldWiper_v3_Cap_Revised_v2.stl FordFocus2012_WindshieldWiper_v3_Ford_ST_Logo_Cap_Revised_v2.stl Note: Best to install when the car is warm.
Print Instructions
Printer Brand: Prusa Printer: I3 MK3S Rafts: No Supports: No Resolution: 0.2 Infill: 20 Filament: FilamentOne PETG Notes: No supports needed.
Part Description
I have a Ford Focus 2012 (Hatchback) and after 9+ years of prolonged heat, the windshield wiper tank cap decided to disintegrate. I whipped this up it Fusion 360 and printed it in PETG. This cap may fit newer ford(s) vehicles. Update 02/23/22: Added a jacket to fit around the outside of the wiper tube along with fitting inside, this will prevent the part from spinning. Feedback from the community, I adjusted the tolerances for the base to fit inside the wiper base. Update 02/25/22: Update the “FordFocus2012_WindshieldWiper_v3_Base_Revised_v1.stl” Increase thread tolerances for certain printers. Update 03/01/22: Fixed thread alignment, simulation was set up incorrectly. Logos will align with the notch on the base. See attached photo. Updated files: FordFocus2012_WindshieldWiper_v3_Cap_Revised_v2.stl FordFocus2012_WindshieldWiper_v3_Ford_ST_Logo_Cap_Revised_v2.stl Note: Best to install when the car is warm.
Print Instructions
Printer Brand: Prusa Printer: I3 MK3S Rafts: No Supports: No Resolution: 0.2 Infill: 20 Filament: FilamentOne PETG Notes: No supports needed.