Sync 3 Screen / Apim Bracket
2013-2020 Ford Fusion
Description
I designed these brackets to mount a Sync 3 screen to a Ford Fusion while doing a Sync 1 to Sync 3 conversion. I did not realise the screen brackets were different between the models, so I had to make these to get the project finished. Hopefully this will help someone in the same situation I was in, as well as save some time and money! Please note, since I didn't have the Ford ones to reverse engineer, you'll have to use the slots to position your screen properly in the bezel. This may take some trial and error, but once you get it aligned it is solid. I printed them using ASA for strength and temperature resistance being inside a hot dashboard.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
I designed these brackets to mount a Sync 3 screen to a Ford Fusion while doing a Sync 1 to Sync 3 conversion. I did not realise the screen brackets were different between the models, so I had to make these to get the project finished. Hopefully this will help someone in the same situation I was in, as well as save some time and money! Please note, since I didn't have the Ford ones to reverse engineer, you'll have to use the slots to position your screen properly in the bezel. This may take some trial and error, but once you get it aligned it is solid. I printed them using ASA for strength and temperature resistance being inside a hot dashboard.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed