Vent Gauge Pod 52mm
2013-2020 Ford Fusion
Description
Print using PETG or other high temp filament since this will be occasionally seeing heat. Fits 2013-2020 Ford Fusions, on the drivers side vent. Ideally, a replacement vent would be used, since this works better when clipping off the retaining tabs that hold the ducting in place. Just glue it in place using some temperature resistant adhesive. Currently designed to fit 52mm gauges.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Print using PETG or other high temp filament since this will be occasionally seeing heat. Fits 2013-2020 Ford Fusions, on the drivers side vent. Ideally, a replacement vent would be used, since this works better when clipping off the retaining tabs that hold the ducting in place. Just glue it in place using some temperature resistant adhesive. Currently designed to fit 52mm gauges.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed