Commander Switch Bracket
2014-2019 Mazda 3
Description
The Mazda 3 has a known issue with the bezel around the center console's Commander Switch that controls in the infotainment system. The bezel can fail after a few years of use and allow the module to drop into the center console. This simple bracket uses existing screw holes in the center console to add extra support and prevent the module from collapsing into your console. I'm terrible at modeling so rather than print it with the screw holes I just drilled them out. Also, your car gets hot so PLA isn't going to cut it. Use ABS when printing this.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
The Mazda 3 has a known issue with the bezel around the center console's Commander Switch that controls in the infotainment system. The bezel can fail after a few years of use and allow the module to drop into the center console. This simple bracket uses existing screw holes in the center console to add extra support and prevent the module from collapsing into your console. I'm terrible at modeling so rather than print it with the screw holes I just drilled them out. Also, your car gets hot so PLA isn't going to cut it. Use ABS when printing this.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed