Front Dash Pocket Amps Dock Bracket
2015 Chevrolet/gmc Colorado/canyon
Description
The tiny front pocket in the dash of the '15 and up Colorado is nearly useless. Even if you shove a wallet or garage door opener in there it'll slide right out if you hit the gas at all. This 'pocket dock' for phone or tablet gives it some purpose. To use the dock you'll want 10lb 'poster' tape - the kind that is a mm or two thick. Place a piece on the top and bottom flat parts, pinch, and insert into the dock. The hole pattern matches industry standard AMPS. Once appropriately installed it is pretty locked in. You're more likely to rip the phone from the mount than the dock from the pocket. There are three different versions. the base version sits very close to the dock edge and is appropriate for RAM ball style docks or other longer, positionable docs. The medium-lower dock hangs below the pocket and is appropriate for most phones and likely horizontal tablets. The 'long' version is good for lower profile docks (eg: magnetic).
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
The tiny front pocket in the dash of the '15 and up Colorado is nearly useless. Even if you shove a wallet or garage door opener in there it'll slide right out if you hit the gas at all. This 'pocket dock' for phone or tablet gives it some purpose. To use the dock you'll want 10lb 'poster' tape - the kind that is a mm or two thick. Place a piece on the top and bottom flat parts, pinch, and insert into the dock. The hole pattern matches industry standard AMPS. Once appropriately installed it is pretty locked in. You're more likely to rip the phone from the mount than the dock from the pocket. There are three different versions. the base version sits very close to the dock edge and is appropriate for RAM ball style docks or other longer, positionable docs. The medium-lower dock hangs below the pocket and is appropriate for most phones and likely horizontal tablets. The 'long' version is good for lower profile docks (eg: magnetic).
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed