Handbrake Hole Plug
2015 Ford Fiesta
Description
If you want to leave a tip, I would appreciate it <3 ETH: 0xc3332e495F1dcA93Aa1c111Cc68e710a64Eaac51 DOGE: DBs37DfixdWaMTrZrbZ3qVDwSPYhkn8Uxe BTC: bc1qqf56wrcfezul5d2weqfce6dvrw6a7gz29gpl2r Couple of guys here posted their designs, but after a while they took it down and wanted some money for it. I needed this for my Fiesta so i designed it, measure it and now its doing its job very well. My fiesta is 2015, but i can imagine it will work on many more models. If you print it and it works on your model, comment what year model do you have. Print flat, no support. Use double tape or super glue to fasten it in the hole. I used super glue, it works well. Do this while handbrake is in upper position and make sure black hole doesnt swallow it (mine did, i needed to print it 2 times :D ). Depending on your printer, you will need to maybe enlarge it or shirink it for a couple of percents to have snug fit. Mine was good at 1:1... If you want to thank me, share my model in relevant groups :)
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
If you want to leave a tip, I would appreciate it <3 ETH: 0xc3332e495F1dcA93Aa1c111Cc68e710a64Eaac51 DOGE: DBs37DfixdWaMTrZrbZ3qVDwSPYhkn8Uxe BTC: bc1qqf56wrcfezul5d2weqfce6dvrw6a7gz29gpl2r Couple of guys here posted their designs, but after a while they took it down and wanted some money for it. I needed this for my Fiesta so i designed it, measure it and now its doing its job very well. My fiesta is 2015, but i can imagine it will work on many more models. If you print it and it works on your model, comment what year model do you have. Print flat, no support. Use double tape or super glue to fasten it in the hole. I used super glue, it works well. Do this while handbrake is in upper position and make sure black hole doesnt swallow it (mine did, i needed to print it 2 times :D ). Depending on your printer, you will need to maybe enlarge it or shirink it for a couple of percents to have snug fit. Mine was good at 1:1... If you want to thank me, share my model in relevant groups :)
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed