Back Seat Cup Holder
2015-2024 Ford Mustang S550
Description
Cup holder for the back seat. Was meant to mimic a 1965 mustang rally pac: https://www.thingiverse.com/thing:6714522 Test fit was from a 2016 Mustang Base GT. Assuming it fits all of the S550's? Prints in 2 halves without needing supports - Glue together. The bezel in the center is to help hide the seam. Bezel prints with supports so the rounded top is up. Added an additional Can sized ring to reduce the size (fits can with koozie), can be used or removed easily. Otherwise, it's pretty big, fits pretty much everything i've thrown at it (within reason). Credit where it is due. Inspiration for where to put this was from Flow State Manufacturing: https://www.flowstateman.com/shop/p/2015-2024-ford-mustang-rear-cupholders where you can purchase one of theirs if you'd like (not affiliated).
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Cup holder for the back seat. Was meant to mimic a 1965 mustang rally pac: https://www.thingiverse.com/thing:6714522 Test fit was from a 2016 Mustang Base GT. Assuming it fits all of the S550's? Prints in 2 halves without needing supports - Glue together. The bezel in the center is to help hide the seam. Bezel prints with supports so the rounded top is up. Added an additional Can sized ring to reduce the size (fits can with koozie), can be used or removed easily. Otherwise, it's pretty big, fits pretty much everything i've thrown at it (within reason). Credit where it is due. Inspiration for where to put this was from Flow State Manufacturing: https://www.flowstateman.com/shop/p/2015-2024-ford-mustang-rear-cupholders where you can purchase one of theirs if you'd like (not affiliated).
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed