Cb Radio Mount
2015 Subaru Forester
Description
Mount to install a Uniden CB mount in place of some decorative trim. Use a solid print for your final part, mark & pre-drill where the factory trim's clips are and attach with screws. This part fits a 2015 Forester RHD. It should suit later models. For LHD users, I *assume* you can flip the model and print but can't say for sure. I've attached STLs for both single and dual DB holders.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Mount to install a Uniden CB mount in place of some decorative trim. Use a solid print for your final part, mark & pre-drill where the factory trim's clips are and attach with screws. This part fits a 2015 Forester RHD. It should suit later models. For LHD users, I *assume* you can flip the model and print but can't say for sure. I've attached STLs for both single and dual DB holders.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed