Fuse Box Lid Spacer
2016 Toyota Camry ASV50R
Description
I tried to install a new dashcam in my Toyota Camry 2016 and found that I cannot use "add-a-circuit kit" in instrumental panel fuse box as its lid sits too close to the fuses. I've found the **euggie**'s design, but decided to create a spacer instead (to keep the original fuse box lid that has a diagram). Notice: the original design is for Camry 2012. I have Camry 2016 (ASV50R) and its fusebox has the same size. STEP file included. Black on pictures - printed in ABS. Grey on pictures - printed in PETG (old design). 03 Mar 2024: I re-designed the spacer so no supports required any longer and it is easier to print in ABS. P.S. I've connected my dashcam into "S/Roof" (battery+) and into a free slot between "Tail" and "EPS-IG1" (ACC).
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
I tried to install a new dashcam in my Toyota Camry 2016 and found that I cannot use "add-a-circuit kit" in instrumental panel fuse box as its lid sits too close to the fuses. I've found the **euggie**'s design, but decided to create a spacer instead (to keep the original fuse box lid that has a diagram). Notice: the original design is for Camry 2012. I have Camry 2016 (ASV50R) and its fusebox has the same size. STEP file included. Black on pictures - printed in ABS. Grey on pictures - printed in PETG (old design). 03 Mar 2024: I re-designed the spacer so no supports required any longer and it is easier to print in ABS. P.S. I've connected my dashcam into "S/Roof" (battery+) and into a free slot between "Tail" and "EPS-IG1" (ACC).
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed