Center Console Organizer
2016 Toyota Tacoma 3rd Gen
Description
Toyota Tacoma 3rd gen (2015+) center console organizer/divider. It is 5.25 inches tall and will work with the trays that sit at the top of the console. For the full divider you will need to print Pole x2 Center wall x1 Side wall x2 Front wall x2 Back wall x2 You can customize this, leaving panels out for larger individual compartments I used .15 layer height for the poles and center wall so they slide together a bit easier. With the other walls laying on the flared spine to print, they will slide in easier if you wanted to try and bump up the layer height more. Also helps a bit to keep the prints stable while printing the top layers. Also used PETG since it withstands higher temps The side walls slant outward at the top ( \ / ) while the front and back slant inward at the top ( / \ ). You will have to put the console in at an angle and turn it into place inside the console. You may have to do this in pieces to get it to fit.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
Toyota Tacoma 3rd gen (2015+) center console organizer/divider. It is 5.25 inches tall and will work with the trays that sit at the top of the console. For the full divider you will need to print Pole x2 Center wall x1 Side wall x2 Front wall x2 Back wall x2 You can customize this, leaving panels out for larger individual compartments I used .15 layer height for the poles and center wall so they slide together a bit easier. With the other walls laying on the flared spine to print, they will slide in easier if you wanted to try and bump up the layer height more. Also helps a bit to keep the prints stable while printing the top layers. Also used PETG since it withstands higher temps The side walls slant outward at the top ( \ / ) while the front and back slant inward at the top ( / \ ). You will have to put the console in at an angle and turn it into place inside the console. You may have to do this in pieces to get it to fit.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed