Cup Holder Insert
2017 Dodge Ram
Description
This coffee mug/cup holder is designed to fit the existing drink holder in the center console of a 2017 Dodge RAM. The coffee cup I use was too big so I designed this holder to accommodate my favorite mug. The inside diameter to this cup holder is 93 mm. The shaft that fits in the existing cup holder has an outside diameter 66 mm (it could be around 75 mm as it's just a tad loose). It's not perfect, but it works. Note: The hole was created during slicing. During the printing, I didn't want it to fill up with resin, so this hole allows it to drain while it prints the 2nd half. It also may eliminate any suction when it gets to this point as well.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This coffee mug/cup holder is designed to fit the existing drink holder in the center console of a 2017 Dodge RAM. The coffee cup I use was too big so I designed this holder to accommodate my favorite mug. The inside diameter to this cup holder is 93 mm. The shaft that fits in the existing cup holder has an outside diameter 66 mm (it could be around 75 mm as it's just a tad loose). It's not perfect, but it works. Note: The hole was created during slicing. During the printing, I didn't want it to fill up with resin, so this hole allows it to drain while it prints the 2nd half. It also may eliminate any suction when it gets to this point as well.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed