Evaporator Coil Cleaner Hood
2017-2024 Tesla Model 3 / Y
Description
This is a remix to print Yonkiman's design standing up on it's side. The largest dimension was 238mm and my Ender3's bed wasn't large enough to print it lying down, but does have enough space vertically, on the Z axis. I added supports for it to stand and help with bridging, and also thickened the shell walls to 2.00mm. Use this to clean the Evaporator Coil on your Tesla Model 3 / Y, when you are changing the cabin air filters. The recommended schedule is every 2 years. I used [Lubegard 96030 Kool-It Evaporator and Heater Foam Cleaner](https://www.amazon.com/Lubegard-96030-Evaporator-Heater-Cleaner/dp/B0007PHD0S/) and OEM Tesla air cabin filters.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
This is a remix to print Yonkiman's design standing up on it's side. The largest dimension was 238mm and my Ender3's bed wasn't large enough to print it lying down, but does have enough space vertically, on the Z axis. I added supports for it to stand and help with bridging, and also thickened the shell walls to 2.00mm. Use this to clean the Evaporator Coil on your Tesla Model 3 / Y, when you are changing the cabin air filters. The recommended schedule is every 2 years. I used [Lubegard 96030 Kool-It Evaporator and Heater Foam Cleaner](https://www.amazon.com/Lubegard-96030-Evaporator-Heater-Cleaner/dp/B0007PHD0S/) and OEM Tesla air cabin filters.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed