Input Shaft Seal Driver

2017 Toyota Highlander

Jan 26, 2026
by Ceramiclover
Thingiverse · CC BY-4.0
Use the built-in measurement tool to verify fit before downloading or ordering.

Description

Uses the Toyota SST or a mallet as a driver. This is the seal behind the torque converter. Based on seal 90311-51013 Tested on a 17ish Highlander.

Print Instructions

Standard FDM printing settings:
- Layer height: 0.2mm
- Infill: 70%
- Supports: As needed
Loading pricing...
🇺🇸Ships from USA to 70+ countries

Resources

Getting Started

Essential tips for printing car parts

Materials Guide

Choose the right filament for your part

ASA vs PETG

Compare materials for car parts

Design for 3D Printing

Best practices for printable designs

All Guides

Browse all learning resources