Rear Sunshade Retainer Bracket
2019 Buick Enclave
Description
The sunshade retainer bracket thing on my 2019 Buick Enclave seems to have dried up in the sun, snapped off and the rear moonroof sunshade went flying back. So I took the remains and reproduced the part for the masses, as it seems like a design flaw from GM to make such a thin piece of ABS to get baked in the sun under tension. You'll have to drill out the old rivets. I drilled the holes out of the metal frame just a bit so I could use a beefier rivet, but I'm getting off topic. Anyway, here you go! This might fit other similar years/vehicles like the GMC Acadia and Chevy Traverse, not sure. Included a "solid plate" version based on a comment, would probably help stiffen it up so thanks for the feedback and sorry for the delay.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
The sunshade retainer bracket thing on my 2019 Buick Enclave seems to have dried up in the sun, snapped off and the rear moonroof sunshade went flying back. So I took the remains and reproduced the part for the masses, as it seems like a design flaw from GM to make such a thin piece of ABS to get baked in the sun under tension. You'll have to drill out the old rivets. I drilled the holes out of the metal frame just a bit so I could use a beefier rivet, but I'm getting off topic. Anyway, here you go! This might fit other similar years/vehicles like the GMC Acadia and Chevy Traverse, not sure. Included a "solid plate" version based on a comment, would probably help stiffen it up so thanks for the feedback and sorry for the delay.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed