Toggle Switch Holder
2019 Toyota Rav4 Gen V
Description
It is holder for a toggle switch, the part of bigger project in my Toyota. It's intended to replace a space filler (from not used position) in Toyota RAV4 (gen V: from 2019) cockpit. Maybe it fits to Toyota Venza 2020 (filler size: 22.2 x 22.2 mm) I use "3 Positions Toggle Switch T80-R with automatic reset" (I bought this switch on Aliexpress) - see photo. The FreeCAD source attached. To remove the filler you need to disassembly a part of cockpit (mounted with clips) on side/bellow of steering wheel. Removing the filler from inside is easy.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
It is holder for a toggle switch, the part of bigger project in my Toyota. It's intended to replace a space filler (from not used position) in Toyota RAV4 (gen V: from 2019) cockpit. Maybe it fits to Toyota Venza 2020 (filler size: 22.2 x 22.2 mm) I use "3 Positions Toggle Switch T80-R with automatic reset" (I bought this switch on Aliexpress) - see photo. The FreeCAD source attached. To remove the filler you need to disassembly a part of cockpit (mounted with clips) on side/bellow of steering wheel. Removing the filler from inside is easy.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed