Trunk Accessory Panel
2019 Toyota Rav4 XA50
Description
A 3D printed version of the RAV4 trunk panel （Tested on my Gen 5). You can build accessory panel with custom cut out. I uploaded the step and f3d project files for your convenience. Print 6 clips __ALONG THEIR SIDE__ for best strength and flexibility. Note: The stock panel is curved and difficult to print with FDM, so I use a flat surface design. It looks good enough for me though.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
A 3D printed version of the RAV4 trunk panel （Tested on my Gen 5). You can build accessory panel with custom cut out. I uploaded the step and f3d project files for your convenience. Print 6 clips __ALONG THEIR SIDE__ for best strength and flexibility. Note: The stock panel is curved and difficult to print with FDM, so I use a flat surface design. It looks good enough for me though.
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed