Center Console Organizer
2024 Tesla Model 3 Highland
Description
An organizer for the center console of the Tesla Model 3 2024 Highland The model includes the organizer itself and a coin/card compartment. These two parts can be printed separately or together. I covered the bottom of the model with foam rubber and felt from the hardware store. I also glued some felt under the side overhangs so that it slides better. I did the same with the visible sides of the coin/card compartment to make it look nicer. Printing recommendations: - Material: PETG (or heat resistant PLA) - Line Height: 0.2mm - with brim (to prevent the corners from lifting) - with supports
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed
Part Description
An organizer for the center console of the Tesla Model 3 2024 Highland The model includes the organizer itself and a coin/card compartment. These two parts can be printed separately or together. I covered the bottom of the model with foam rubber and felt from the hardware store. I also glued some felt under the side overhangs so that it slides better. I did the same with the visible sides of the coin/card compartment to make it look nicer. Printing recommendations: - Material: PETG (or heat resistant PLA) - Line Height: 0.2mm - with brim (to prevent the corners from lifting) - with supports
Print Instructions
Standard FDM printing settings: - Layer height: 0.2mm - Infill: 70% - Supports: As needed